"> d-i davit international-hische d-i Type A SWL-15t
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 2 verified suppliers & service companies for d-i davit international-hische in the Maritime Network Find suppliers →
d-i davit international-hische

d-i Type A SWL-15t

d-i davit international-hische d-i Type A SWL-15t is a shipboard unit in the Davits group, classified in the source as Gravity Davit. It is normally installed at lifeboat, rescue-boat or liferaft embarkation stations on exposed deck. Its primary duty is to launch and recover or lower survival craft safely using the approved davit arrangement. In service it interfaces with davit arms, winch, wire falls, sheaves, brakes, hydraulic/electric drives, limit switches and survival craft attachments. Compared with neighboring entries in the same product family, this record is the exact d-i davit international-hische d-i Type A SWL-15t variant; the model designation should be retained unchanged when matching onboard documentation and spares. For exact limits, settings, test values and approved maintenance criteria, refer to the manufacturer documentation for the exact figure.

d-i davit international-hische d-i Type A SWL-15t

Components & Design

Component data being added…

Technical Data

swl t 15

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Wire-fall wear or corrosion, typically indicated by broken strands, diameter loss or failed inspection
Brake or winch deterioration, typically indicated by poor load holding, jerky lowering or overheating
Sheave, pin or bearing wear, typically indicated by noise, binding or uneven wire tracking
Hydraulic/electrical drive fault, typically indicated by failure or slow movement during launching/recovery
Limit switch, release or interlock malfunction, typically indicated by incorrect indication or inability to complete the launch sequence

Service & Maintenance

Inspect structure, falls, sheaves, winch, brake, pins, corrosion protection, controls, limit switches and launching path; dynamic/static tests and replacement criteria must follow SOLAS, class and manufacturer-approved procedures.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry approved wire-rope service items, brake parts, hydraulic seals/hoses where fitted, limit switches, control relays and lubrication/service components.
Equipment Model #129765 · ✓ still in production