"> Fukushima FK-5T
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 9 verified suppliers & service companies for Fukushima in the Maritime Network Find suppliers →
Is Fukushima your company? Claim this page
Fukushima

FK-5T

Fukushima FK-5T is identified in the source list as a deck crane. It is mounted on a reinforced pedestal or foundation on the vessel's working deck, cargo deck or offshore handling area. Its purpose is to lift and position stores, cargo, equipment or offshore loads within the crane's approved operating envelope. The existing database record provides no additional model-specific operating figure beyond the listed designation and category. The crane integrates slewing, luffing, hoisting, brakes, controls and structural load paths, with hydraulic or electric drive depending on the installed model. The exact model designation identifies safe working load, outreach, reeving and drive arrangement; these values must be confirmed from the crane certificate and manufacturer documentation.

Components & Design

Component data being added…

Technical Data

lifting capacity t 5

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Wire-rope deterioration caused by corrosion, broken wires, crushing or poor spooling, resulting in visible damage or unreliable hoisting
●Hydraulic leakage or drive failure caused by hose, seal, pump or valve faults, resulting in slow, jerky or unavailable movement
●Brake or winch deterioration caused by wear or contamination, resulting in load drift, poor holding or abnormal noise
●Slew-bearing, pin or sheave wear caused by cyclic loading and inadequate lubrication, resulting in play, vibration or rough movement
●Limit, overload or control-system fault caused by sensor, wiring or calibration problems, resulting in alarms, inhibited motion or loss of protective functions

Service & Maintenance

Inspect wire ropes, hooks, sheaves, pins, brakes, winches, hydraulic equipment, slew arrangement and structural foundations. Lubricate specified points and examine hoses and cylinders for leakage or chafing. Function-test controls, emergency stop, limit devices and overload protection according to the approved procedure. Inspect high-load welds and pedestal areas for corrosion, cracking or deformation. Verify hook safety devices and reeving condition before lifting. Refer to manufacturer and class documentation for exact inspection intervals, wire-rope criteria, test loads and allowable wear.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep hydraulic seals and hose consumables where applicable, control switches or sensors, brake parts, sheave or bearing components and manufacturer-recommended electrical or lubrication items. Critical hooks, ropes and overload components must remain within the approved configuration. Heavy structural and slew-bearing parts are normally strategic spares.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Fukushima?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #127899 · ✓ still in production