"> JRC (Japan Radio Co) JAN-701B 19-inch
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
JRC (Japan Radio Co)

JAN-701B 19-inch

JRC (Japan Radio Co) JAN-701B 19-inch is listed in the source as a marine ECDIS within the Radar & ECDIS group. Equipment of this type is typically installed at the main bridge navigation console, normally with redundant or backup arrangements according to the vessel's approved bridge layout. Its primary duty is electronic chart display, route monitoring and integration of navigation sensor data, and it depends on approved chart data, position and heading inputs, bridge networks, display hardware and correctly controlled software or configuration. Neighboring variants can differ in rating, size, interface, approval basis or arrangement, so the complete model designation and actual nameplate data are important for identification. It normally interfaces with GNSS, gyro or heading sensors, speed log, AIS, radar overlay where fitted, bridge network and ship power. For any exact capacity, pressure, voltage, tolerance, wear limit or setting not stated in the source, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

display size 19-inch
imo compliant True
chart format S-57/S-63

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Loss of GNSS, heading or speed data caused by sensor or network faults can produce invalid-position warnings, frozen vectors or degraded route monitoring
Chart database or software problems caused by failed updates, corrupted media or configuration errors can lead to missing charts, update warnings or unavailable functions
Display or processor failure caused by ageing components, overheating or power-supply faults can cause blank screens, restarts or loss of one station
Network or interface faults caused by damaged cabling, switch failure or incorrect addressing can remove AIS, radar overlay or other integrated data
Incorrect safety settings or route parameters caused by configuration changes can generate inappropriate alarms or fail to provide the expected warning behavior

Service & Maintenance

Verify chart status, sensor inputs, alarm behavior, backup arrangements, power supplies, display condition and network health. Check that route-monitoring and safety settings correspond with the vessel's procedures and approved configuration. Use manufacturer documentation and flag-state or class requirements for exact test and update procedures.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Typical onboard support includes approved data media as applicable, fuses, fans, power-supply or interface modules and replacement input devices according to the maker's support concept.
Equipment Model #126751 · ✓ still in production