"> TK Elevator Marine MonoSpace Marine 500kg 0.5m/s 6-deck
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
Is TK Elevator Marine your company? Claim this page
TK Elevator Marine

MonoSpace Marine 500kg 0.5m/s 6-deck

TK Elevator Marine MonoSpace Marine 500kg 0.5m/s 6-deck is identified in the source list as a marine elevator / lift. It is normally installed or arranged in the vertical access shaft between decks. Its purpose is to move personnel or permitted loads between decks. The source record provides no additional model-specific operating figure beyond the listed designation and category. The equipment is based on car, guide system, drive, doors, brakes and safety interlocks. The exact model designation distinguishes the installed configuration from neighboring variants in the same category; refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

capacity kg 500
speed ms 0.5
decks 6
drive type MRL

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Door or interlock failure caused by wear, misalignment or sensor faults, resulting in refusal to run, repeated door cycling or unsafe door indication
●Drive, brake or hydraulic fault caused by wear, leakage or electrical problems, resulting in slow travel, abnormal stopping or inability to move
●Guide, roller or suspension wear caused by inadequate lubrication, corrosion or alignment problems, resulting in vibration, noise or poor ride quality
●Limit-switch, position-sensor or control failure caused by wiring or electronics faults, resulting in incorrect floor stopping or system alarms
●Emergency-power or communication failure caused by battery, charger or wiring faults, resulting in unavailable emergency lowering, alarm or communication functions

Service & Maintenance

Inspect doors, interlocks, car and landing controls, guide components, suspension or hydraulic equipment, brakes and emergency devices. Function-test door protection, emergency stop, alarm and emergency-lowering or rescue arrangements using approved procedures. Check machinery spaces and shaft areas for water ingress, corrosion and loose fasteners. Investigate leveling errors, vibration or repeated resets before continued service. Keep access to lift machinery and rescue controls clear. Refer to the manufacturer documentation for the exact figure for suspension, brake, hydraulic, load-test and inspection criteria.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep door rollers or guides, interlock switches, fuses, relays, position sensors, hydraulic seals where applicable and manufacturer-recommended control or drive components. Critical safety parts must match the approved elevator design.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for TK Elevator Marine?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #114679 · ✓ still in production