"> TK Elevator Marine MonoSpace Marine 300kg 2.5m/s 10-deck
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
TK Elevator Marine

MonoSpace Marine 300kg 2.5m/s 10-deck

TK Elevator Marine MonoSpace Marine 300kg 2.5m/s 10-deck is listed as a Marine Elevator / Lift within the Elevator & Access category. It is typically installed within the vessel’s vertical access trunk, with machinery and controls arranged around the lift shaft and served decks. Its engineering role is to move personnel or stores safely between deck levels while integrating with shipboard power, door interlocks and emergency functions. The complete model designation should be retained when matching drawings, certificates, service information and spare parts because neighboring variants may differ in configuration even when they share the same equipment family. The exact shipboard arrangement and interfaces remain installation-specific and should be checked against the vessel’s approved drawings and equipment documentation. Where an operating value, tolerance, wear limit or setting is not explicitly stated in the source data, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

capacity kg 300
speed ms 2.5
decks 10
drive type MRL

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Door-interlock contamination or misalignment can prevent the safety circuit from proving closed, seen as a refusal to run or an intermittent door fault
Guide, roller or suspension-component wear can increase friction and vibration, noticed as rough travel or abnormal noise
Drive or brake degradation can impair smooth starting and stopping, seen as jerking, stopping errors or brake-related alarms
Position or limit-sensor faults can corrupt deck detection, noticed as incorrect leveling or failure to complete a travel command
Moisture or loose electrical connections in the control system can cause intermittent trips, resets or unavailable service

Service & Maintenance

Inspect door interlocks, landing interfaces, guide components, drive/brake condition, control cabinets, emergency functions and evidence of corrosion or water ingress. Verify smooth travel and accurate landing at the served decks. Safety-device testing and acceptance criteria must follow the approved vessel and manufacturer procedures.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Useful onboard spares include approved door/interlock components, sensors, indicator lamps or modules, fuses and other manufacturer-recommended electrical consumables.
Equipment Model #114673 · ✓ still in production