"> FläktGroup Marine MAXXAIR Centrifugal 5000m3h accommodation
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
Is FläktGroup Marine your company? Claim this page
FläktGroup Marine

MAXXAIR Centrifugal 5000m3h accommodation

FläktGroup Marine MAXXAIR Centrifugal 5000m3h accommodation is identified in the source list as a centrifugal fan. It is normally installed or arranged in the fan room, duct section or machinery-space ventilation opening. Its purpose is to move ventilation air through the listed shipboard space. The source record provides a stated power of 2.5 kW. The equipment is based on fan impeller, casing, motor, bearings, dampers and controls. The exact model designation distinguishes the installed configuration from neighboring variants in the same category; refer to the manufacturer documentation for the exact figure.

2.5 kW
Power

Components & Design

Component data being added…

Technical Data

air flow m3h 5000
static pressure pa 500
power kw 2.5
fan type centrifugal
zone accommodation

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Airflow loss caused by fouled blades, blocked dampers, dirty screens or duct restriction, resulting in poor space ventilation
●Bearing or motor deterioration caused by wear, inadequate lubrication or overheating, resulting in noise, vibration or high current
●Impeller imbalance caused by dirt, corrosion or physical damage, resulting in increased vibration and structural noise
●Flexible-connection or mounting failure caused by vibration and age, resulting in air leakage, transmitted vibration or abnormal movement
●Control, damper or starter fault caused by actuator, wiring or electrical problems, resulting in inability to start, stop or establish the required airflow direction

Service & Maintenance

Inspect fan blades, casing, bearings, motor, guards, flexible connections, dampers and foundations. Clean accumulated dust, grease or salt that can alter balance or restrict airflow. Trend vibration, motor current and bearing condition where practical and investigate changes from normal operation. Check rotation direction after electrical work and verify remote start, stop and fire-damper interlocks. Inspect weather louvers and ductwork for corrosion, obstruction and water ingress. Refer to the manufacturer documentation for the exact figure for bearing, belt, airflow and motor limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep bearings, belts where fitted, flexible connectors, motor or fan components, damper actuators, filters or screens and manufacturer-recommended starter or control parts.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for FläktGroup Marine?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #110439 · ✓ still in production