iAlert 4ch
Istec Marine iAlert 4ch — Vibration Monitoring. It is normally installed on rotating machinery with sensors connected to local or centralized monitoring electronics. Its primary purpose is to trend vibration condition and warn of developing imbalance, misalignment, bearing or structural problems. Compared with periodic handheld measurements, fixed monitoring can provide continuous trending and alarms but depends on correct sensor mounting and configuration. The model designation identifies the listed configuration, but no additional meaning is inferred from the model code beyond the information supplied in the source record. For exact ratings, dimensions, settings, capacities, materials and variant-specific limits, refer to the manufacturer documentation for the exact figure.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Service & Maintenance
Inspect sensor mounting, cables, junction boxes, monitoring modules and channel configuration. Compare trends with operating condition and investigate sustained changes. Check alarm and trip interfaces under the approved procedure. Refer to the manufacturer documentation for the exact figure for alarm values and calibration criteria.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →