"> Evac Evac 910M
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 7 verified suppliers & service companies for Evac in the Maritime Network Find suppliers →
Is Evac your company? Claim this page
Evac

Evac 910M

Evac Evac 910M is identified in the source list as a vacuum toilet system. It is installed in the freshwater or process-water treatment system between source water, storage and the intended consumers. Its purpose is to condition, disinfect, soften, mineralize, desalinate or convey sanitary waste according to the listed treatment process. The source record provides the existing record note 'Water Treatment, marine sanitary / water treatment'. Filters, chemical dosing, ultraviolet lamps, membranes, softening media, pumps, valves, vacuum equipment, sensors and controls may be included depending on the process. The exact model designation and any source-listed capacity distinguish process size and treatment arrangement from neighboring water-treatment units; refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

system description vacuum toilet system (medium vessel)

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Reduced treatment or sanitary performance caused by fouled filters, exhausted media, scaled membranes, aged lamps or blocked piping, resulting in poor water quality, low flow or system alarms
●Dosing, regeneration or vacuum failure caused by empty chemical supply, pump faults, air leakage or control errors, resulting in incorrect water chemistry or poor sanitary operation
●Sensor or conductivity fault caused by fouling, calibration drift or wiring problems, resulting in implausible readings or alarms
●Pump or valve failure caused by wear, blockage or electrical faults, resulting in low treatment flow or inability to route water correctly
●Leakage caused by seal, housing, membrane or piping deterioration, resulting in water loss, vacuum loss or unstable process conditions

Service & Maintenance

Inspect filters, membranes, lamps, dosing equipment, softener vessels, pumps, valves, vacuum equipment, sensors and sample points as applicable to the installed process. Maintain hygienic conditions during opening of potable-water treatment equipment. Trend pressure, vacuum and water-quality indications and investigate abnormal values promptly. Verify alarms, regeneration, diversion, flushing or shutdown functions after maintenance. Store chemicals and treatment media according to approved procedures. Refer to the manufacturer documentation for the exact figure for dosing, replacement, cleaning and operating settings.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep filter elements, membrane or lamp components, approved treatment media, dosing-pump or vacuum-system service parts, seals, valves, sensors and sampling consumables recommended for the installed process. Chemicals must be approved for the intended water service. Confirm exact replacement parts against unit configuration.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Evac?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #68627 · ✓ still in production