VL-400(si)
Veth Propulsion VL-400(si) — Integrated L-Drive rudder propeller for electric propulsion.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Blade surface inspection for cracks, corrosion pits, cavitation burns, and erosion damage on blade faces
Leading edge and blade tip examination for nicks, chips, and damage that may cause vibration or cavitation
Detection of bent or warped blades through visual inspection and dynamic vibration monitoring during operation
Propeller shaft inspection for bending, wobble, and deviation from axial alignment using runout measurement
Hub condition assessment, particularly rubber hub wear and degradation in service (critical for hubs >10 years old)
Fastener integrity check including propeller nuts, bolts, cotter pins, and keyway components for corrosion and looseness
Propeller-shaft seal inspection for deterioration, fishing line damage, and mechanical wear
Gearbox and bearing lubrication condition and adequate marine grease application to shaft and transmission interfaces
Type-general inspection and maintenance points for this equipment category — not model-specific.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →