OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 6 verified suppliers & service companies for Survitec in the Maritime Network Find suppliers →
Is Survitec your company? Claim this page
Survitec

Spiromatic 90U

Survitec Spiromatic 90U — Marine firefighting SCBA, maritime industrial emergency use, smoke escape.

Components & Design

Component data being added…

Technical Data

Type Entry-level Self-Contained Breathing Apparatus (SCBA)
Mask Design S-Mask breathing valve and plug-in regulator
Pressure Protection Positive pressure mask design
Regulator High-capacity with safety valve
Harness Construction Padded shoulder straps with adjustable hip belt buckles
Backplate Open design for ventilation and reduced weight with integrated carrying handle
Certification Approved for maritime and industrial firefighting use

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Thermal integrity and flame resistance degradation

Examine jacket, trousers, and helmet for visible burn marks, melting, discoloration, or material brittleness. Test heat resistance at seams and high-stress areas. Verify compliance with EN469:2020 thermal barrier performance limits (radiant, convective, contact heat protection)

Waterproof membrane integrity and breathability loss

Inspect for cracks, tears, or delamination in the four-layer membrane structure. Test breathability by measuring water vapor transmission rate. Verify tape-sealed seams remain intact. Check for liquid water penetration resistance

SCBA positive pressure system failure and regulator malfunction

Test mask positive pressure integrity with regulator safety valve activation. Verify audible chest alarm functions under noisy conditions. Inspect S-Mask for cracks and check plug-in regulator for blockages. Test ambient air hatch operation where applicable

Helmet structural integrity and electrical insulation degradation

Inspect ProBuddy helmet for cracks, impact damage, or material deformation. Test electrical insulation capacity (E2/E3). Verify chinstrap Nomex material condition and attachment security. Check polycarbonate visor for cloudiness, scratches, or coating loss

Glove and boot protective properties compromise

Inspect leather gloves for tears, brittleness, or water damage. Verify waterproof/breathable lining integrity. Check heat-resistant rubber boots for cracking, hardening, or sole separation. Confirm aramid lining protection against cuts and penetration

Type-general inspection and maintenance points for this equipment category — not model-specific.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →
Equipment Model #149064 · ✓ still in production