"> Scott Safety / 3M Scott Safety Air-Pak 75i 4.7L 300bar-B
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
Scott Safety / 3M

Scott Safety Air-Pak 75i 4.7L 300bar-B

Scott Safety / 3M Scott Safety Air-Pak 75i 4.7L 300bar-B is listed as a Self-Contained Breathing Apparatus (SCBA) within the Breathing Apparatus category. It is typically installed in machinery, cargo, enclosed-space entry or firefighting service depending on whether the equipment is fixed, portable or worn by personnel. Its engineering role is to detect hazardous atmospheres or provide breathable air so crew can work safely during emergencies and confined-space operations. The complete model designation should be retained when matching drawings, certificates, service information and spare parts because neighboring variants may differ in configuration even when they share the same equipment family. The exact shipboard arrangement and interfaces remain installation-specific and should be checked against the vessel’s approved drawings and equipment documentation. Where an operating value, tolerance, wear limit or setting is not explicitly stated in the source data, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

cylinder 4.7L 300bar
marine approved True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Sensor or cell ageing can cause drift or failed calibration, seen as unstable or inaccurate readings
Blocked sampling paths, filters or sensor inlets can slow response, noticed during bump or functional testing
Battery or power-supply failure can make portable or electronic equipment unavailable
Regulator, hose, mask or seal leakage on breathing equipment can reduce delivered air, noticed as pressure loss or poor face seal
Moisture, contamination or corrosion can damage connectors and alarms, causing intermittent faults or failed self-tests

Service & Maintenance

Perform the maker-specified functional, leak, alarm and calibration checks appropriate to the equipment. Inspect sensors, hoses, masks, cylinders, regulators, batteries and charging arrangements as applicable. Calibration gas values, cylinder test requirements and sensor-life limits must be taken from approved manufacturer and statutory documentation.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry approved sensors or cells, filters, batteries, seals, mask or hose consumables and calibration/test accessories appropriate to the installed equipment.
Equipment Model #135233 · ✓ still in production