"> Furuno FAR-2837S-BB 8ft
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 105 verified suppliers & service companies for Furuno in the Maritime Network Find suppliers →
Is Furuno your company? Claim this page
Furuno

FAR-2837S-BB 8ft

Furuno FAR-2837S-BB 8ft is identified in the source list as a marine radar system. The display and controls are normally installed on the bridge, with the radar antenna and transceiver equipment located on the mast or another suitable elevated position. Its purpose is to detect and display surrounding targets and coastline returns to support navigation, collision avoidance and situational awareness. The existing database record provides no additional model-specific operating figure beyond the listed designation and category. A marine radar installation combines antenna, transmitter or solid-state source, receiver, processing, display and heading or speed inputs, with the exact architecture depending on the model. The exact radar model distinguishes scanner technology, band, display functions and interfaces; these specifications must be confirmed from approved manufacturer documentation.

Components & Design

Component data being added…

Technical Data

antenna size 8ft
imo compliant True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Antenna drive or rotation failure caused by motor, gearbox, bearing or power faults, resulting in loss of scan or radar alarm
●Transmitter or RF-stage failure caused by component aging or electrical faults, resulting in weak or absent target returns
●Heading, speed or position-input failure caused by sensor or network faults, resulting in incorrect stabilization or target vectors
●Display or processing fault caused by software, power-supply or hardware problems, resulting in frozen, blank or corrupted presentation
●Antenna-window contamination or water ingress caused by salt, moisture or seal deterioration, resulting in reduced range, intermittent faults or corrosion

Service & Maintenance

Inspect antenna rotation, scanner condition, waveguide or cabling, power supplies and bridge connections. Verify that heading, speed and position inputs are valid and compare radar presentation with known targets. Check alarms, guard functions and target-tracking behavior using the vessel's approved test procedure. Inspect exposed scanner housings for salt, water ingress and damaged seals and maintain safe RF isolation before work aloft. Back up configuration data where supported and document software or hardware changes. Refer to manufacturer documentation for exact performance tests, magnetron or transmitter servicing and alignment procedures.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep fuses, power-supply modules or approved electronic spares, scanner drive consumables, seals and interface components recommended for the installed radar. If the design uses a serviceable transmitter component with a finite life, follow the manufacturer's spare strategy. Ensure replacement modules preserve type approval and software compatibility.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Furuno?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #126885 · ✓ still in production