"> SAAB R5 Supreme 4ft
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 7 verified suppliers & service companies for SAAB in the Maritime Network Find suppliers →
SAAB

R5 Supreme 4ft

The SAAB R5 Supreme 4ft is a marine radar system. It is normally installed on the bridge with scanner mounted high on a mast or radar platform. It is designed for target detection, collision-avoidance support and navigation in restricted visibility. The operating principle relies on radio-frequency transmission and echo processing to display target range and bearing. The supplied entry gives no additional verified capacity, pressure, power or dimensional figure for this model. Compared with neighbouring models, the relevant differences are frequency band, antenna size, transmitter technology, display integration and tracking functions; these must be confirmed from the installed documentation rather than inferred from the model designation alone. Service and survey attention should concentrate on scanner rotation, target presentation, heading/speed inputs, antenna/RF path, alignment and power. For exact ratings, dimensions, tolerances, test limits and model-specific settings, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

frequency band X-Band
antenna size 4ft
imo compliant True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Loss of transmitted radar energy caused by transmitter or power faults, noticed as weak or absent echoes
Scanner rotation failure caused by motor, gearbox, belt or power faults, noticed as antenna-stopped alarm or frozen picture
Heading/speed-input failure caused by sensor or interface faults, noticed as incorrect stabilization, trails or target vectors
Receiver/signal-processing fault caused by RF, processor or software problems, noticed as poor sensitivity, false echoes or unstable picture
Antenna, waveguide or cable water ingress caused by seal deterioration, noticed as intermittent performance, corrosion or RF alarms

Service & Maintenance

Check scanner rotation, target detection, gain/clutter controls, heading and speed inputs, range/bearing alignment and known-target presentation where practicable. Inspect scanner, pedestal, RF path, seals and structural mounting. Verify performance-monitor functions where fitted, blind-sector information and bridge power supplies.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry fuses, selected cooling fans, display/control components, interface converters and manufacturer-recommended transmitter or scanner spares appropriate to the radar technology. Keep weather seals, RF connectors and approved maintenance consumables.
Equipment Model #126865 · ✓ still in production