"> Metos Marine WD-7 Marine gas
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 2 verified suppliers & service companies for Metos Marine in the Maritime Network Find suppliers →
Metos Marine

WD-7 Marine gas

The Metos Marine WD-7 Marine gas is a commercial marine dishwasher. It is normally installed in the galley or scullery with water, drainage, energy and dosing connections. It is designed for repetitive washing and rinsing of crockery and utensils. In operation, wash/rinse pumps circulate heated water and detergent through spray systems. The supplied entry states a power rating of 6.0 kW; this information is retained unchanged. Compared with neighbouring models, the relevant differences are rack size, heater type, pump capacity, dosing system and cycle programs; these must be confirmed from the installed documentation rather than inferred from the model designation alone. Service and survey attention should concentrate on filters, spray arms, pumps, heaters, drains, door interlock and dosing. For exact ratings, dimensions, tolerances, test limits and model-specific settings, refer to the manufacturer documentation for the exact figure.

6.0 kW
Power

Components & Design

Component data being added…

Technical Data

power kw 6
capacity 6 GN 1/1
fuel gas

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Heating or wash-process failure caused by heater, burner, pump or control faults, noticed as poor temperature rise or incomplete cycles
Water/steam/drain fault caused by scale, blocked filters, valves or pumps, noticed as alarms, leakage or standing water
Door seal or interlock failure caused by wear, noticed as leakage or inability to start safely
Fan/spray/dosing failure caused by motor, nozzle or chemical-feed faults, noticed as uneven cooking or poor cleaning results
Temperature sensor or controller failure caused by probe/electronics faults, noticed as unstable operation or error codes

Service & Maintenance

Inspect heating source, water system, drains, filters, pumps/fans, door seals and interlocks, dosing or steam systems where fitted, and secure marine mounting. Verify ventilation and safe electrical/gas isolation. Descale and clean only using manufacturer-approved methods.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry door seals, fuses, temperature sensors, water filters, pump/fan service parts, spray/dosing components and manufacturer-approved burner/ignition parts for gas versions. Maintain specified cleaning and treatment consumables.
Equipment Model #113246 · ✓ still in production